To safely reset or wipe all memory presets on your ZLEDS controller, follow this exact procedure:
🛠️ Reset Instructions:
-
Make sure the correct Access ID is set and accepted.
If the wrong ID is used, the controller will not respond properly (you’ll see a black screen with an exclamation icon). -
Open the ZLED Bit Editor App.
-
Go to the Menu > Access ID section.
-
In the Access ID field, type the word:
RESET(in all caps). -
Wait a few seconds after submitting.
-
Go back to Menu > Access ID, and now enter your original PIN (security code).
-
Power off the tail lights, wait 3–5 seconds, and power them back on.
🧠 What happens next?
All memory slots and stored functions will be wiped. The controller is now blank and must be reprogrammed.
✅ Use the Magic Hat switches to verify functions are cleared.
📤 Upload all presets again using the Bit Editor app or sync defaults from the cloud.
Leave a Reply
You must be logged in to post a comment.