ONE MAN ARMY

If the ZLED Bit Editor app fails to connect or doesn’t show the editor tabs, it’s usually due to one of the following issues:

✅ Checklist to Resolve the Issue:

1. Ensure Lights Are Powered On

   • The lights must be on (running lights active) for the Bluetooth module to power up and broadcast.

2. App Permissions

   • Make sure the app has all permissions enabled — especially Bluetooth and Location. Without these, the scan and connection process will fail (Android 10+ requires location access to scan Bluetooth).

3. First-Time Pairing

   • On first launch, the app will scan for nearby devices. Look for a device named ZLEDSxxxx.

   • Tap the name to connect. If nothing appears, turn your lights off for 5 seconds and back on, then restart the app.

4. Set Your Access ID

   • After connecting, open the menu and set your Access ID (PIN). This is required to unlock the editor tabs.

   • If you skip this step, tabs will remain hidden.

5. No Tabs Showing After Setup?

   • Fully close the app and power cycle the lights.

   • Open the app again; it should auto-connect and unlock the tabs.

6. Firmware Compatibility

   • Ensure your controller has firmware 1.60 or above for best compatibility with recent app versions.

💡 If all else fails:

• Try using another phone/tablet to rule out device-specific Bluetooth or permission issues.

• Contact us with your controller version and app behavior for direct help.